Satin Bracelet with Beads
You'll need:
3 satin laces (1 m length each), beads, clasp, pin switch, round-nose pliers, pliers, connecting rings, CA glue.
Apply CA glue inside the pin switch.
Glue 3 laces and clamp with pliers.
String the beads to the other edge of the pieces. All three segments should have the same number of beads.
Tie the knots.
Weave a braid 5 cm long.
Pull the bead onto the leftmost drawstring and weave it into the pigtail.
Wrap the bead with an empty cord while continuing to weave the braid.
Add a bead to the left edge and braid it. Weave all the beads in this way.
Weave a braid 5 cm long.
Apply CA glue on the other pin switch, then glue the cuts and clamp them with the pliers.
Add the lock in this way: open the small connecting ring, string the carabiner loop on it, fasten to the trailer and lock the ring.
Connect the second connector to the small ring and fasten to the carabiner clasp.
No comments
Write a comment