Butterfly From Glass

You'll need:

Instructions:

Contact paper should fit closely inside the mold. To achieve a good fit, place the trimmed contact paper inside the mold and run a pen along the sides of the mold. Trim away markings as needed and place contact paper to the side.

Create and place a pattern in the center of the mold. Peel the backing off the contact paper and place in the mold sticky side up, over the pattern.

Adjust pieces as necessary and press them firmly onto the contact paper.

Pour cement slowly and evenly into the mold. Do not move the mold while the cement is drying.

Wait approximately thirty minutes to one hour for the cement to harden. The cement will warm as it hardens. Once it has cooled and set remove the stone from the mold.

Peel off the contact paper and clean off any excess cement covering the glass. You may clean the cement with a paper towel, sponge, or craft knife.

Fill in any remaining air holes by mixing a small amount of outdoor cement into a paste and rubbing the cement into the holes in a circular motion. If your project gets any marks or you have contact lines on the cement, you may smooth the cement out with sandpaper.