​Bracelet With Cord Knots

You'll need:

Instructions

Take one length of cord, fold it in half. Lay it down on your work surface so it forms a loop. For my bracelets, I used 2 pieces of cord, each 22" long, and that made a 6" long bracelet (including the clasp). Use more cord if you have thicker cord or want a longer bracelet.

Loop the bottom cord over and then under the tails of the loop you made.

Gently pull the knot tight, shaping it a bit so it lies flat and the ends are even.

Using sharp scissors, cut all four ends after the tape so the tape holds the cord together. This type of cord unravels quickly, so we immediately added epoxy to the ends. Some tutorials show gluing on the sides of the cord but then it shows, so we glued the ends and only a millimeter between each cord to hold them together invisibly. We mixed the two-part epoxy with a toothpick and used the toothpick to spread on the glue and coax a little between the cords. Let the epoxy dry for a minute, just so it's tacky but not hard (this epoxy dries rock hard).

Place the cord into the opened ribbon crimp and use a toothpick to push it all in. It's wriggly and will try to escape, but the epoxy (still pliable but not totally glued) will help hold it together. Close the crimp with needle nosed pliers and let dry 24 hours.