Organizer for Car Seat Back
You'll need:
Fabric for organizer;
Net for lower pocket;
Supple transparent plastic for lower pocket;
Non-glued vlies;
2 big lace eyelet;
Scissors;
Clips;
Ruler;
Chalky pencil;
Sewing machine;
Threads;
Iron.
Instructions
Decide what size organizer you need. It consists of a base to which 2 pockets are sewn. The width of the base and pockets is the same, the length of the base should be slightly larger so that the pockets are convenient to use.
Details:
- for each pocket: 1 piece of fabric 28x33 cm, 1 piece of net or vinyl 22x33 cm, 1 strip for fastening the pocket 5x33 cm;
- for the basics: a piece of fabric 53x33 cm and the same part made of vlies;
- for the valve from below, a piece of fabric 10x33 cm, a piece of vlies 4x30.5 cm;
- for the upper loop 1 piece of fabric 10x40 cm.
Allowances are accounted for. Cut out the details.
Prepare both strips for the top edges of the pockets. To do this, fold them as a slanting inlay and iron.
Strip the top edges of both pockets with strips: surround the edge with stitches and stitch.
Put the plastic part of the pocket on the fabric part of the pocket so that the front side of both parts looks up, combine the lower and side edges and grind on 3 sides (side and bottom), departing from the edge of 0.5 cm.
Now you need to connect the two pocket blocks. Place them one above the other as they will be located in the organizer, then fold them by aligning the upper edge of the lower block with the lower edge of the upper block and fasten with clamps. Lay the stitch back 0.7 cm from the edge.
Fold the bottom valve part along in half, face inward, and secure with pins. Sew the stitches by stitching the short sides.
Turn out, iron the seams and put the part made of vlies in half folded in half. Lay the line below, fixing the vlies.
Mark the places for the eyelets and insert them.
Sew the valve to the bottom of the lower pocket in the center. Stand back from the edge of 0.5 cm.
Fold the buttonhole part in half lengthwise inward and lay the stitch along the long side. Turn out a detail and iron.
Attach the loop detail to the upper edge of the pockets and stitch.
Connect the base parts and the part to the pockets. Put the part of the base made of non-woven fabric, on it - the part of the base made of fabric face up, on it - the part with the pockets turned upside down, fasten with clamps and sew along the perimeter, leaving one short side open for turning out.
Turn out the organizer, wrap the open side allowances inward and iron, and sew this edge on the machine.
For additional fixation of pockets, lay a line along the seam of the part with pockets.