​Nice Beads Rose

You'll need:

Instructions

Take a piece of wire of a meter and fold in half. Collect 16 beads. Place them in the middle of the wire, where you make a fold.

After you did it, put 16 pieces of material, and with one edge go through the beads 4 loops. Eight more beads and draw wire through the space of the fourth beads of the previous loop. Do the same manipulations with the second end. The next ridge will be directed down. Take 12 pieces of material, and push the end through the fourth of the low loops. Such a procedure must be woven three times, and in the fifth, string 14 beads, and pass the wire through the eighth beads into a near loop.

Proceed to work on the border of the petal. Rewind the wire with a length of 40 cm and put it into one thing in the center of the petal at the top of the loop. On the first edge, cast on six beads. Weaving does not change its pattern. The hue of the edging should be distinctive from the petal. Then its relief will be more noticeable.

Attach a piece of wire under the beads. String eight beads, and add 12 beads at the edges. Twist everything. The scheme of the next stage of weaving is as follows, on the basis we put on 12 beads, on the rest - 14. After all this, spin the three pieces of wire and get the figure "eight". In the thinnest place, tie another wire with beads. On each half of the weave, there will be 21 beads. On the main part, we string 25 beads and put it into a bead of an arch standing next to it. In the end, twist everything together.

After 6 petals and 5 sepals are ready, begin to collect in a step-by-step way. Roll up the petal, it will be the core. Attach it to the leg. Also attach the next one and wrap the first one. Wind florists tape on them and fix it. Wrap further petals with tape and bend them a little. The sepals will be at the top.