You'll need:
Beads of any colour you like;
Bigger beads for edging;
Monofiber thread, scaffolding or thin wire
Instructions:
The pattern of weaving a scarf is a net with large holes. Weaving must begin from the bottom up, partially expanding the work. Start crafting the craft from the bottom corner, that is, from the suspension itself. Dial one white bead and thirteen transparent, then 1 pebble and again transparent glass. To get the suspension, walk the needle back through the pebbles and the remaining beads. Then string three more transparent and as many white ones.
In the photo, you can see a schematic drawing in which the first glass is indicated in red, the elements through which you need to go through in the following bands are blue. Immediately weave the next suspension. String three light beads, thirteen transparent, pebbles again and again transparent. Walk the needle back and again collect three little things transparent and white. Another photo also shows in red where the needle will go when stringing the second strip, and the next row is marked in blue.
Again, take two light, then 1 dark blue and again two light beads. Weave a new strip as you did in the previous row. Weave such a picture: two light and three blue glass. Then make the dark of the previous row. Continue the pattern further by stringing three blue and two white. The lilac color in the photo shows the beads of the second row through which the needle passed. In the fourth row type two white and one blue, and at the end again white. String five dark beads again and close the resulting rhombus, in which the motif will pass through the entire accessory.
The fifth row also begins with the color of the beads that were mentioned above. Like all subsequent bands it will begin with the suspension, and then go with a grid according to the presented scheme. Weaving should continue until the decoration reaches the required length and width.
When you will weave the last row, Instead of cells, you need to collect four glass pieces so that a smooth edge appears. In the middle of the work process, you will need to weave the fastener or make it separately, and then just sew it on.
