​Wire Flowers Earrings

You’ll need:

Special board for working with wire (“Happy Jig”);

Side cutters;

Flexible aluminium wire;

Earwire gold-look;

Small and bigger beads;

Needle for beads;

Nylon threads;

Hammer.

Instructions

Insert chips of various shapes into the board.

AS AN ALTERNATIVE, THE WIRE CAN BE BENT MANUALLY WITHOUT ADDITIONAL TOOLS.

Bend the aluminum wire around the chips and give it the shape of five petals.

Attach earwire to one of the petals.

Bite off the unnecessary ends of the wire with side cutters and bend around the middle of the flower.

If necessary, flatten with a hammer.

String beads on a thin wire (about 5 cm long), add a larger diameter bead at the end. Thread again through all the beads.

Fasten the thread in the middle of the flower.

Repeat the steps from step 3 by executing the petals of arbitrary shape.

String the beads on a thin wire to a length of approx. 20 cm

Wires with beads to wrap around the middle of the flowers.

Both ends of each wire are tightly bound.