​Daffodils Garden Lighter

You'll need:

Cans with 7,5 cm diameter and 8 cm height;

Yellow foam-rubber 2 mm wide, A3 sheet for each flower;

Mat acrylic paints (orange and green colors);

Round wooden bar with 15 mm diameter and 1 m length;

Glasses for candles and candles;

Small wood screw;

Green natural stem fibre;

Small plastic ladybugs;

Scissors;

Drill;

Drill tools with 1 and 5 mm diameter;

Flat brush;

Hairdryer;

Invisible glue;

Screwdriver.

Instructions

According to the diameter and height of the cans of yellow foam rubber cut petals and strips for flower cups.

With a sponge, draw a little orange acrylic paint and shade the edge of the strips with it.

Put the petals of the flower in the middle on the selected can and heat it with a hairdryer so that you can use your fingers to give the petals the desired shape.

Stick strips of foam rubber around the cans with glue and allow to dry completely.

The edge of the corolla of the flower is heated with a hairdryer and slightly bent.

Drill carefully drill 5-6 small holes with a diameter of 5 mm (so that the candle light was visible) and in the middle - a hole with a diameter of 1 mm. Open the holes and edges of the petals with orange acrylic paint.

At the end, glue the flower to the can from the bottom side.

Drill a hole in the middle of the wooden bar, then paint the bar with green acrylic paint and allow to dry.

Attach the bar with a wood screw to the bottom from the inside of the can. In addition, curl a cup of a flower with green bast fiber, tie a fiber with a bow and stick small ladybugs to the flowers.